Soler & Palau EC-N / EP-N

Soler & Palau EC-N / EP-N electrically heated fans are suitable for heating and drying wet areas in industry and construction. The most common applications are in production and storage halls, public rooms, churches, construction sites, garages or workshops. The Soler & Palau EC-N / EP-N electric heating units are installed on the wall / wall with hinges. The casing of the electric heating unit is made of sheet steel, coated with a baked-on paint.

Enclosure

The cabinet is made of sheet steel, coated with a firing varnish. A swivel bracket made of sheet steel is mounted on the cabinet to allow adjustment of the position of the unit.

The impeller

The impeller is axial, moulded from AL sheet metal. The blades are power optimised.

Motor

The motor of the heating units is asynchronous with short armature and shielded pole for continuous operation. The motor has plain bearings with grease packing for life. The motor has overload protection. IP24 protection.

Electrical connection

Connection is by cable which is routed out of the enclosure through a grommet. The unit is designed for fixed mounting.

Regulation

Speed control is carried out externally by means of a CR 25 switch or a CR 25 switch and a TR thermostat. Three different operating modes can be selected by the switch (fan only, fan and half heating power, fan and full heating power). If a thermostat is also used, the unit starts automatically in the mode indicated on the CR switch. In addition, it is possible to set whether the thermostat starts the whole unit (fan and heater) or only the heater (when the fan is running continuously).

Variants

Soler & Palau EC-N - wall-mounted

• EC-3N basic version 3 kW/230 V
• EC-5N basic version 5 kW/400 V
• EC-9N basic version 9 kW/400 V
• EC-12N basic version 12 kW/400 V
• EC-15N basic version 15 kW/400 V

Soler & Palau EP-N - portable version

• EP-3N basic version 3 kW/230 V
• EP-5N basic version 5 kW/400 V
• EP-9N basic version 9 kW/400 V
• EP-12N basic version 12 kW/400 V
• EP-15N basic version 15 kW/400 V

Installation

The unit is mounted on the wall using the hanger supplied. The minimum distances from the walls are shown in the illustration. Care must be taken to ensure that the inlet and discharge sides are not covered by the heating rod enclosure. In this case, the air flow through the cabinet could be restricted, thereby increasing its temperature and causing a fire hazard. If the air temperature rises, the unit will be switched off by the safety thermostat, whose reset button is located on the top of the cabinet. The switch and thermostat are wall mounted.

Datasheet: